Industrial John Deere Classifieds (free)
On this page, I will list any "wanted" items, and I will gather information about parts and products for sale for the John Deere industrial tractors. If you would like a WANTED plea, a product, part, or whole tractor put on this page, just email me. I will post it here if I feel it is appropriate. It will be put on after a few days (at most-hopefully only a week or two). This is a free service.
Go back HOME.

Last Changed on May 12, 2004
DISCLAIMER
I cannot and WILL NOT quarantee anything on this page! Any product's quality, authenticity, or value IS NOT quaranteed by me. If you find that something is wrong, please email me at moparwhs@hotmail.com so I can try to correct it. If a deal goes bad, do not complain to me, I cannot do anything about it!

WANTED ADS
  • Wanted, or Trade

    Rear support that mounts the JD67 loader to the transmission/motor of a JD750. I have the mount for a JD650 that I would be willing to trade. Please email me gvoelker@snet.net or call 860-267-9288
  • Wanted: John Deere 300 B

    East Texas/Shreveport/Oklahoma Area, Contact John Crawford @ 214-284-6207, or email jwcrawford1970@yahoo.com

  • Wanted: Parts for John Deere 440 ICD

    Rear axle, battery box cover, oil filter assembly (& oil filter part number) & exhaust stack. Please respond in writing to Marty@hillsmountain.com for my phone number. Thank you. Marty

  • 2010W Rear Hub

    Wanted: Rear wheel hub for JD 2010W Gas utility tractor loader/backhoe part number T15351T.

    Email at PennaBowHunter@aol.com
  • 440 Diesel Crawler

    Wanted: 440ICD Crawler with loader and pto
    Call Scott Leonard @ 413-549-3619 or E-mail Leonardfarm1@netzero.com
  • JD350 crawler

    Wanted JD350 crawler (bare - no dozer or loader) with 3 point hitch. Email at mjb8279@aol.com or call 360-834-7989.
  • I am looking to buy John Deere 840s, parts or whole in any condition. Contact Chris in MN. Phone: 1-612-670-1141 or Email at ccshea@ecenet.com
  • Model 50 backhoe swing cylinder shaft

    Wanted: John Deere Model 50 backhoe swing cylinder shaft. Contact at: dlg@skaya.com

  • John Deere JD350 or JD450

    Wanted: John Deere JD350 or JD450 crawler loader. Email at: jaya@mcburney.com

  • End cap valve for a 440IC with backhoe

    Wanted: End cap valve for a 440IC with backhoe. It's the inlet and exit cap for the controls with the threads. It is casting number 15478-22c. It has a 6 control setup. Contact Bob at: GOVELRJ@sysadm.suny.edu

  • John Deere 67 or 70 front end loader

    Wanted: Complete John Deere 67 or 70 front end loader. Contact Scott Blitz at mailto:blitzsd@yahoo.com or 248-634-9268

  • Short block for JD300

    Wanted: A running or rebuilt short block for a John Deere 300, block # T24963-JD. It is a 3 cylinder diesel w/ 50 hp. Contact at: locustcolts@msn.com

  • Wanted: Parts for a JD401CD

    Wanted parts for a JD 401CD. Front-end loader, backhoe, Will buy whole tractor if it has the front end loader and backhoe. Tractor does not need to run. Call (740)982-2390 or (740)503-9665 Ask for Jerry

  • Wanted: Cylinder head for 2010 diesel

    Contact Jeff at (845) 254-5206
  • Wanted: Mast frame for 95A backhoe
    Part number: AU40917, used on a JD400, I have tried quite a few places with no luck. Thanks for any help!

    Contact at: freem4@futurelnk.net
  • Wanted: John Deere 840 parts
    840 hood metal, left and right hoods. Instrument panel for electric start and front bumper.

    My 840 lost it's pieces due to tinkerers in the Waco Texas area in the late 80's/early 90's. It was initially delivered new and worked in the area till then. Any guesses who may have had such a rare Deere? Phone 905-987-1597 or 519-368-2427.
  • U11087U-rod end for bucket indicator
    used on the 71, 700 or 710 loader. I found the last NOS part in Maine and UPS lost it in shipping. Or if anyone could provide me with some dimensions to make the part, that would also work. Thanks for your help, Del. e-mail---jdeere435@peoplepc.com
    or 313-621-6540
  • John Deere 644G loader parts
    I am trying to repair a burned 644G loader with a 6081 engine. I need an injection pump, harmonic balancer, and air intake. Call David at: 1-888-240-9246 or email at: davidcarter@planttel.net
  • John Deere 420U parts
    I am looking for the following parts for a John Deere 420U:
    M-4326T Screen grille - require two (used), sub for M1906T
    AM 1809T cover
    AM 2211T FRAME (Model U)
    AT 237T crank, starting with pin (U)
    M 1800 T guard PTO shaft
    M 2593T spring
    M 2278T wrench rim
    M 2440T bushing for 420 U 3 point hitch
    If you can supply all or any of these used parts, please contact mickeyd@sasktel.net
  • Wanted: 3 New 18.00 x 26 Goodyear 10 Ply Sure Grip Tires For JD 840 Earth Mover. Road grader tread.
    Please contact John at 574-353 7912 or email john@craigwelding.com
  • Wanted: Diesel cylinder head for my 1010. Please contact George at blue1@3rivers.net. Thank you.
  • Wanted- 1955 John Deere Model 40C Crawler Dozer, Serial Number 68735. Last known location to be in South West Ontario, Canada.

    Contact Gord at Shaping@Wendover.on.ca if you have any information regarding this machines current location.
  • WANTED-John Deere AI, BI or DI any condition even a basket case. I seek to restore a tractor for my own collection. I would also consider other industrial JD two cylinder industrials as long as they are complete and in good condition.

    Contact Steve @ Steve@MktgInc.Com or 1-800-645-9850. Thanks for reading my ad.
  • WANTED-John Deere 2010 Industrial Diesel Engine
    Cash payed for complete runing engine or bare block. Must have casting # T17513. I would prefer the complete engine although the block would be fine as long as no cracks or defects.

    Contact at: vetterfarm@cablespeed.com
  • WANTED-1936 to 1941 John Deere model BI or BR Tractor in fair condition to restore at a reasonable price.
    Call Curtis at (989) 832-9571
    or e-mail: Crtssktt@aol.com
  • Want to purchase an AI, prefer one that needs to be restored, even if it is a carcass. Please call or Email what you have. I'll promptly reply and have my banker all set up. I want this for my personal collection, and have items to trade if you'd like. B.C. Cushing, ph 603-358-0104 eves., Keene, NH or Email at cushingsons@earthlink.net


FOR SALE ADS
John Deere 830 Industrial

830I serial #8306631. Tractor history is unknown but under the yellow paint the base coat on the engine, fenders and other parts that would not be unique to an 830I is green. Tractor located in New York. Contact Carl at RbrtsnCr@aol.com

John Deere 830 Industrial

830I serial #8303802. Electric start, very low hours on engine and crankshaft, runs very good, bareback with foot throttle, power steering works excellent. $8000 or best offer above or below. Located it SE Iowa.

Contact at: 319-646-2720

Two used 18.4x26 (15x26) tires

Two used 18.4x26 (15x26) tires, don't match, one BF Goodrich Powergrip, other is a Goodyear Traction Torque. Both are ten ply. I'd say about 40% tread left. Some shallow cuts and weatherchecking, but still good tires. $300 or best reasonable offer.


Located in northern Ohio

Contact Brandon at:
(440)647-2808
moparwhs@hotmail.com
Nozzles for early JD 3010,3020,4010,4020

I have available some nozzles for early 3010,3020,4010,4020 JD tractors that use the American Bosch/Scintilla nozzles. These were also used on early JD500A, JD500B, JD500C, JD510 and JD600 industrial units. These are core but were removed from running units and are complete assemblies. Price is $30 each.

Email Jeff Birk at: planetp@earthling.net
JD400 with Loader and Backhoe

JD 400Loader/Backhoe, 1964, fully operational, good rubber, diesel, new motor 1994.

Tractor Serial number T5W3D 048528T
Serial number M53TW 064241T

$5,000.00 OBO, located in NH. call 603-352-8866 for info
831 front end loader

831 front end loader, fits 440, 1010 JD crawler. Complete, except for hydraulic hoses & mounting bolts. $700. For pictures and more info visit http://members.cox.net/rhondathiels
For Sale: JD350

John Deere 350 crawler loader backhoe, good condition, $9900.00
Email: jkac202@webtv.net
256-237-2484
Willard Stewart
Anniston, Al.
4039 diesel engine long block

JD rebuilt 4039 diesel engine long block. the serial number TO4039D411196* indicates that this is an unstructured replacement block. the block, head, etc.are fully reconditioned, new injectors, water pump etc. etc. All new gaskets. Head and pan are not final ssembled so buyer can verify rebuild. Sits on wooden engine cradle. Comes with additional block (damaged) with spares including injector pump etc...

This is the same block found in 1990 and newer backhoes, bulldozers, industrial JD tractors, ag JD tractors, generator sets, wood chippers, pumps, 4X4 forktrucks etc. Dealer price is $8,200.00 with core. Must sell for $2,800.00 which is slightly more than the price for a reconditioned head. Please call Kevin in CT. (860) 349-1156 or e-mail configmgmt@hotmail.com
JD350 parts--wide crossbars and axle extensions

A set of wide crossbars and the axle extensions for putting 33" pads on an early 350. Contact Lavoy at: llwilcox@earthlink.net. You can also visit his website at: www.jdcrawlers.com
830I, serial number 8306636
SOLD!

For Sale: John Deere 830 Industrial diesel with pony start. Owned for 12 years. Starts right up, runs good, more rare than electric start models.Good tin, seat etc. Also has original pto shaft included. Painted incorrect JD Green over original yellow by previous owner. Mostly original. This is the right tractor to do a nut and bolt restoration on. If you want the rarest of the rare this is it serial #8306636. Reluctantly selling for $9,000.00 firm. I have seen 830's not as nice as this one sell for twice this price. Ayone collecting the 30 series tractors will snap this up. For purchase or more information call Kevin at (860) 349-1156 in Connecticut. Or e-mail configmgmt@hotmail.com
JD401-B
(Click on pictures to enlarge)


For Sale - John Deere 401-B Industrial Tractor, Good Tires, New Paint, New Seat, Runs Great! The Serial # is 213257T and the engine is #316568T. Please call:

Robert Lansford
P.O. Box 422
Fowlerton, TX 78021
830-373-4346
NIECYDL2@HOTMAIL.COM

830I, serial number 8305560
(Click on pictures to enlarge)

This is an 830 Industrial with electric start, rare tractor, one of 82 built, good sheet metal, runs good, asking $10,000.00.

You can contact the owner, Ed Fitch, at (386) 423-1819
The tractor is located in Florida

MI, serial number 10349

The rear axle housings have been turned 90 degrees, to the same position as a normal M. This made the rear end rise, and now it looks like a dragster!! If you wish to contact the owner; Charles Campbell,
email at anne.m.campbell@gte.net
Or call 601-919-2049

The website at http://www.vintagetractors.com has many L, LA, and M series parts for sale, which can fit the industrail versions. Most are pictured.

It also includes a new reproduction drawbar for the MI. Here is a picture:
Click for a link to the website
The website at http://www.antiquejohndeere.com often has L, LA, or LI parts for sale. Try it.
From "A Restorer's Guide to Parts and Services"

Bruce Johnson-Reproducton seats for John Deere AI, BI, DI.
5N550 Cochise, Maple Park, IL 60151.
Phone 708-365-5001

DISCLAIMER
I cannot and WILL NOT quarantee anything on this page! Any product's quality, authenticity, or value IS NOT quaranteed by me. If you find that something is wrong, please email me at moparwhs@hotmail.com so I can try to correct it. If a deal goes bad, do not complain to me, I cannot do anything about it!


Go back HOME.